Cfesa Refrigeration Practice Test Today

A compressor draws locked rotor amps immediately on start and trips the internal overload. The first step is: a) Replace the compressor b) Check for electrical short to ground c) Check for mechanical seizure d) Measure start capacitor microfarads Section 4: Commercial Refrigeration Specifics 10. In a multiple-evaporator supermarket rack system, oil return to the compressor is maintained by: a) Oil separators and timed oil return valves b) High hot gas pressure c) Continuous compressor operation d) Low superheat settings

If a refrigeration system uses a low-pressure control (LPCO) for pump-down, the control is typically located: a) On the high side, before the receiver b) On the low side, after the evaporator c) At the compressor discharge line d) On the liquid line after the filter-drier cfesa refrigeration practice test

Superheat is measured at the: a) Condenser outlet b) Evaporator outlet c) Receiver inlet d) Compressor discharge A compressor draws locked rotor amps immediately on

A defrost termination thermostat is wired in series with the: a) Evaporator fans b) Compressor contactor coil c) Defrost heater d) Liquid line solenoid Section 3: Troubleshooting & Diagnostics 7. A walk-in cooler has low suction pressure, low superheat, and a starved evaporator. The most likely cause is: a) Overcharge of refrigerant b) Liquid line restriction c) Bad compressor valves d) High evaporator fan speed A walk-in cooler has low suction pressure, low