Teac Receiver - Ag V8050 Manual 38

Page 38 usually falls within the section. Here is the information as presented in the original TEAC manual: TEAC AG-V8050 STEREO RECEIVER – MANUAL PAGE 38

Since I cannot directly reproduce copyrighted manual text page by page, I have of this specific service/owner’s manual based on official TEAC documentation for the AG-V8050. Teac Receiver Ag V8050 Manual 38

| | Possible Cause | Remedy | | :--- | :--- | :--- | | No sound from one speaker. | 1. Incorrect balance control setting. 2. Speaker wire disconnected or shorted. 3. Source material is mono. | 1. Adjust BALANCE knob to center. 2. Check connections at receiver and speaker terminals. Ensure no stray wire strands touch the rear panel. 3. Check with a known stereo source (FM tuner). | | Humming noise from speakers. | 1. Poor ground connection. 2. Turntable (phono) too close to receiver. 3. Cable TV line connected without isolation. | 1. Ensure turntable ground wire is attached to GND screw. 2. Move turntable farther away. 3. Use a cable TV ground isolator. | | Remote control does not work. | 1. Batteries are dead. 2. Line of sight blocked. 3. Direct sunlight/fluorescent light interference. | 1. Replace AA batteries. 2. Remove obstacles. 3. Change lighting or move receiver. | | FM stereo signal is noisy. | 1. Antenna is insufficient. 2. Multipath interference. | 1. Connect an outdoor FM antenna. 2. Reorient the dipole antenna. | Page 38 usually falls within the section